Classic Moth Plans Mistral Hull Panel Offsetts

Despite being the tippiest Classic Moth design out there, more Mistral designs are built in the U.S than any other design - by a long shot. Although a competent Laser or Sunfish racer has no problem handling a Mistral (after an initial "lets get acquainted session" to get over the wobbliness) other, less experienced sailors, get sucked in by the simple stitch and glue, bend-em-up, building process. Sometimes they have been very surprised when they get on the water.

More information on the Mistral design can be found here.

The front end of a Mistral - this is Mike Parsons.

The back end of a Mistral - this is John Zs.

For those not to be dissuaded by my introductory warning and desire to build a Mistral, here are the Mistral panel offsets in both DXF and PDF formats.

(Note!: These offsets are only the beginning - you will need at least three bulkheads, a transom, and framing around the mast step to finish up the shape.)

The section dimensions of the fast Y2K Mistral can be found here.

A DXF drawing of the hull panel (you will need 2 identical panels to form a hull). Use the pop-out icon (top-right) to open in another tab to print or download.



A PDF file with the offsets. Use the pop-out icon (top-right) to open in another tab to print or download.



A short synopsis of Derek Chesters original instructions for the Mistral build. Again, use the pop-out icon (top-right) to open in another tab to print or download.

Related Posts by Categories