After days of prep work, the hull assembly began today. The method of construction of this boat is called "stitch and glue", meaning the individual parts are wired together before being sealed with epoxy at the seams. First, matching pairs of strakes are stacked up and 1/16" holes are drilled every 4 inches along the rabbet edge. A simple cardboard gage helped space the holes. Once the four pairs of strakes were drilled, stitching began.
About 34 holes were drilled along the length of each strake. For stitching, a large number of copper wire pieces were cut at about 3 inches each. With the end of the strake aligned with the end of the bottom panel, a corresponding hole was drilled in the bottom panel. The soft copper wire was then passed through and twisted to draw the panel together. Planks were stuck under the ends of the bottom panel to give some curve and allow proper alignment of the stitched pieces. Finally, the project is starting to vaguely look like a boat. Total hours 22.00.
0 komentar:
Posting Komentar